Tuesday, January 5, 2010

Best of the Torsos so far

This is the best work I have received so far. The spotlight is on you guys now... I am hoping to see some excellent work from you in the next three weeks.
-hamza

Sunday, January 3, 2010

Measuring the Subject: Revisited

Hey everyone, Here's everything that we have talked about in class regarding measuring your subjects (Building, Model). Now that most of you have already practiced these techniques in one way or the other, this should make more sense.

1. Establish two points on your paper as the desired height of pose (top and bottom). Draw a perpendicular through these points as the middle line of the subject.

2. Locate the middle point of line (1/2). Now, holding pencil at arm's length, find the middle point on the subject before you. From the middle point get quarter points (up and down).

3. Take the greatest width of the pose. Compare it to the height. In this drawing, it comes just above the right kneecap (about 1/3). Lay the width equally on each side of your middle point crossways on your model.

4. Your two lines will cross at this point. It is the middle point of your subject. Remember this point on the model. You work out from it in all directions.

5. Now, with plumb line, or eye, locate all the important points that fall beneath one another. (In this drawing the subject's right heel is directly underneath her hair at the forehead, the knee under the nipple, etc.)

6. Start by blocking in head and torso and, from the head, sight straight up and down and straight across, all the way up and down the figure.

7. For the angles, sight straight on through and establish a point on the line where it falls under a known point. (See line of chest and nipples. The known point is the nose. This locates right nipple)

8. If you constantly check points opposite, points underneath and where the angles emerge, after having established height, width, and division points - you can't possibly go wrong with the accuracy.

(Measure by holding pencil ALWAYS at an arm's length)

Lighting and Shadows

Click on the image to enlarge
All lighting information can be split up into 3 broad parts:
1. Highlights (the whites)
2. Halftones (the grays)
3. Shadows (the blacks)

There are two other portions that you need to keep in mind:
4. Reflections
5. Casting Shadow (the masses that are responsible for casting Shadows)

So ideally... the way that we have been going about it... we attempt the drawing in roughly two phases. Blocking (Identifying and outlining all the portions from 1-5) AND Final Light.

Also use the side of the pencil for drawing shadows, tones and values, and the sharp point for the contours